Virtual TapeServer 8.4 Supplemental Installation Guide

34 | Virtual TapeServer Supplemental Installation Guide
Parameter Description Values
autocopy_pool_dest_
poolname
Specifies the destination path on the
target system for the copy operation
as specified by poolname. You must
specify this parameter for each pool
listed for the autocopy_pools
parameter if a different poolname is
desired. Set this parameter to the
desired path on the target system;
the pool is copied from the source to
the specified path on the target
server. In all cases, ensure that no
virtual tape matches the name of any
virtual tapes to be copied. Also, the
vaults on the originating and target
systems cannot reside in the same
GFS file system, if GFS is used. You
can omit this parameter and set the
autocopy_pool_dest_ANYPOOL
parameter to specify the target path
for all pools.
Pool on a target
system, such as
server1:pool1
autocopy_pool_dest_
ANYPOOL
Specifies the destination path on the
target system for the copy operation
for all pools set by autocopy_pools.
Specify this parameter if you do not
set the autocopy_pool_dest_
poolname parameter for each pool in
autocopy_pools but the paths on the
originating and target systems are
not the same.
Pool on all target
systems, such as
server1:pool1
rep_enable Enables AutoCopy for virtual tapes in
VTLs.
Default value: NO
YES or NO