Virtual TapeServer 8.4 Supplemental Installation Guide

ManualsBrandsHP ManualsServerHP NonStop G-Series

Enabling and Configuring AutoCopy and Instant DR | 35

Parameter Description Values

rep_delay Specifies the time to wait (in

seconds) before starting to copy data,

for virtual tapes in VTLs. This is an

optional parameter that provides a

delay to the host so that it can issue

a mount for verification. When a

mount request is received, any

running AutoCopy operation for the

virtual tape is terminated and the

partially copied data is removed

from the remote system.

0 - 86400

rep_bwlimit Specifies the maximum bandwidth (in

thousands of bytes per second) to be

used for each AutoCopy operation, for

virtual tapes in VTLs. If set to

greater than 0, the approximate

bandwidth used for the copy will be

limited to the value specified.

Integer

Here is an example configuration:

autocopy_enable='YES'

rep_enable='YES'

autocopy_pools='VTS001 VTS003 VTS004'

autocopy_target_ANYPOOL='VTS-DR'

rep_delay='60'

rep_bwlimit='100'

Or:

autocopy_enable='YES'

rep_enable='YES'

autocopy_pools='DR1 DR2'

autocopy_target_DR1='SVR08'

autocopy_target_DR2='SVR08:/VAULT00/DR2_AU'

5. Click SAVE.

6. Restart the TapeServer process on the Manage System Tasks page.