Virtual TapeServer 8.4 Supplemental Installation Guide

Hardware Information for Legacy Installations | 65
6. Remove SCSI cards from the server as follows:
Note This order must be followed or the upgrade will not work. Every HP ProLiant DL585
server has SCSI and Fibre Channel cards in the same physical slots. A Fibre Channel
card is always in slots 5 and 6. You will see slot numbers on the chassis above each
slot. These numbers are visible on the inside and outside of the chassis.
The following order of SCSI card removal must be followed:
a. Remove the SCSI card in slot 3 and install the first Fibre Channel card in slot 3.
b. Remove the SCSI card in slot 4 and install the second Fibre Channel card in slot 4, if
necessary.
c. Remove the SCSI card in slot 2 and install the third Fibre Channel card in slot 2, if
necessary.
d. Remove the SCSI card in slot 1 and install the fourth Fibre Channel card in slot 1, if
necessary.
e. Remove the SCSI card in slot 7 and install the fifth Fibre Channel card in slot 7, if
necessary.
f. Remove the SCSI card in slot 8 and install the sixth Fibre Channel card in slot 8, if
necessary.