Virtual TapeServer SCSI-to-FC Adapter User Manual

7-11
Chapter 7: Using the Serial/Telnet Interface
Fibre Channel Configuration
This menu allows for setting the Fibre Channel Address method, Hard Address value, discovery
mode, WWN overrides, tape backup settings, default map value, and FC port mode.
Figure 7-9. Fibre Channel configuration menu
Fibre Channel Configuration Menu
X.X.XX XXXXXX XXXXXX-XXX_XXXXXXXXXXXXXX
01/07/2010 10:31:55
Current Fibre Channel Configuration - Port 0:
FC Link Status : DOWN
Node Name : 10:00:00:E0:02:02:49:C7
Port Name : 10:00:00:E0:02:22:49:C7
Port Mode : AutoSense, Soft AL_PA
AL_PA : 0x00
Discovery Mode : Manual Discovery Only
Buffered Tape Writes : Enabled, Queue Depth = 5
Current Default Map : 'Auto Assigned'
Port Speed : 2 GigaBit
FC Port Init Delay : 0 Seconds
1) Change World Wide Node Name High 2) Change World Wide Name Low
3) Toggle Port Mode 4) Change ALPA Value
5) Toggle Discovery Mode 6) Toggle Buffered Tape Writes
7) Change Buffered Tape Queue Depth 8) Change Default Map Value
9) Edit FC Override Settings A) Toggle Port Speed
B) Change Port Init Delay
X) Return to previous menu
Note: For In-Band Management to be operational, WWN naming schemes MUST
be compliant with IEEE Fibre Channel Format 1, where the left-most hexadecimal
character (the NAA field) of the WWN is '1'. Further, the upper nibble of the third
byte (the sixth hexadecimal value from the right) must be a value of '0' or'1'.