Virtual TapeServer SCSI-to-FC Adapter User Manual

7-14
Chapter 7: Using the Serial/Telnet Interface
Figure 7-10. Fibre Channel configuration menu
Following are descriptions for each of the override settings:
• Select 1 to toggle the Hi-Sup Bit between SET and CLEAR. The default setting is CLEAR.
This option should be toggled to SET when the server uses the Hi-Sup bit to scan for FC LUNs
greater than eight.
• Select 2 to toggle the Force FCP Response Code between OFF and ON for support of
Compaq-specific HBAs #223180-B21 and #120186-001. The default setting is OFF.
Fibre Channel Override Configuration Menu
X.X.XX XXXXXX XXXXXX-XXX_XXXXXXXXXXXXXX
01/07/2010 10:31:55
Current Fibre Channel Override Configuration - Port 0:
Hi-Sup Bit in INQUIRY DATA is CLEAR
Force FCP Response Code is OFF
PRLI Payload - INITIATOR & TARGET Bits Set
PRLI ACCEPT Payload - TARGET Bit Set
PRLI ACCEPT Payload - FC CONFIRM Set
Target Reset mode is ALTERNATE
LUN Reset mode is ALTERNATE
Force FLOGI in Private Loop is DISABLED
1) Toggle Hi-Sup Bit Setting
2) Toggle Forcing FCP Response Code
3) Toggle Initiator/Target Bit Settings in PRLI
4) Toggle Initiator/Target Bit Setting in PRLI_ACC
5) Toggle FC Confirm Setting in PRLI_ACC
6) Change Target Reset Mode
7) Change LUN Reset Mode
8) Toggle Forcing FLOGI when in Private Loop
X) Return to previous menu
Note: Normally, override settings should not be changed except when
directed to do so by an authorized HP technician.