Virtual TapeServer SCSI-to-FC Adapter User Manual

7-21
Chapter 7: Using the Serial/Telnet Interface
Figure 7-17. Select current map
Enter the number from the column on the left side of the table to select a map and make it
‘Current’. For example, entering ‘3’ from the picture above would select map named ‘SCC
Map’ on the Fibre Channel Port and make it a ‘Current’ map.
• Select 2 from the Device Mapping Main Menu to display the content of the ‘Current’ map.
This option displays all the entries in the map. Information in the local part of the address(left)
depends on the type of protocol for which the map is defined. The specific device address
information depends on the protocol/port where the device resides. Mapping a device to the
same port where it resides is not allowed. (i.e. you can not map a disk on FCP Port 0 to an
address on FCP Port 0.)
Select Current Map
X.X.XX XXXXXX XXXXXX-XXX_XXXXXXXXXXXXXX
01/07/2010 10:31:55
Current Map for FCP Port - 'Auto Assigned'
+-------+------------+------+--------------------------------+
| MAP # | Protocol | Port | Map Name |
+-------+------------+------+--------------------------------+
| 1 | FCP | 0 | Indexed |
| 2 | FCP | 0 | Auto Assigned |
| 3 | FCP | 0 | SCC Map |
+-------+------------+------+--------------------------------+
Page # 1 out of 1 pages.
Total Number of Maps = 3
Enter(N=Next, P=Prev, Number=Select, X=Exit) >