Virtual TapeServer SCSI-to-FC Adapter User Manual

7-24
Chapter 7: Using the Serial/Telnet Interface
Figure 7-21. Map edit menu
• Select 1 from the Map Edit Menu to edit the name of the current map. The name of the
Indexed map may not be changed. Map name also cannot be left empty.
Figure 7-22. Edit map name
• Select 2 from the Map Edit Menu to edit entries in the current map. This screen allows the user
to navigate up and down the map entries and create or remove entries. Device lists are also
available to the user to make it easier to identify the device to be mapped. Mapping device to
its native port/bus is not allowed. The information needed to create entries is protocol/port
dependent.
Map Edit Menu
X.X.XX XXXXXX XXXXXX-XXX_XXXXXXXXXXXXXX
01/07/2010 10:31:55
Current Map: FCP Port 0 - Name 'Indexed'
1) Edit Name
2) Edit Map Entries
3) Clear Map
4) Fill Map
X) Return to previous menu
Command >
Note: Enter the number of one of the available selections or enter ‘X’ to
exit to the Device Mapping Main Menu.
Current Name: New Map Name
Enter New Name (X=Cancel) > New Map
Map Name Changed to: 'New Map'