Virtual TapeServer SCSI-to-FC Adapter User Manual

7-26
Chapter 7: Using the Serial/Telnet Interface
The following is an example of adding an entry for an FCP map:
Figure 7-24. Adding an FCP port entry
The following is an example of a Device List generated for an FCP port:
Figure 7-25. Device list for FCP port
Select number from the left column ‘Num’ to add a device to the map. Selecting a device
where LUN=’-’ will add all LUNS for this target. If the selected device is already mapped, an
error message will appear to warn the user about adding a duplicate device. ‘N’ and ‘P’ con
-
Enter desired lun address > 0
Select Protocol (0 - SCSI, 1 - AF, X=Cancel) > 0
Select SCSI Port: Port# = ? (0-7,X=Cancel) > 1
Device List
X.X.XX XXXXXX XXXXXX-XXX_XXXXXXXXXXXXXX
01/07/2010 10:31:55
SCSI Port 1 Device List:
+-----+-----------+-----+------+---------+
| Num | Target ID | LUN | Type | State |
+-----+-----------+-----+------+---------+
| 1 | 3 | - | - | - |
| 2 | 3 | 0 | TAPE | ACTIVE |
| 3 | 4 | - | - | - |
| 4 | 4 | 0 | DISK | ACTIVE |
| 5 | 5 | - | - | - |
+-----+-----------+-----+------+---------+
Page # 1 out of 2 pages.
Number of entries in the device table = 8
Enter(Number=Select, N=Next, P=Prev, X=Exit) >
Note: If the operator selects a device with LUN ‘-‘, all LUNs for this Target
will be added to the map.