Virtual TapeServer SCSI-to-FC Adapter User Manual

7-27
Chapter 7: Using the Serial/Telnet Interface
trols allow scrolling up and down the device list. ‘X’ will bring the user back to the ‘Edit Map
Entries’ display table.
Creating an Entry
The user can create an empty map or use an existing map to pre-enter devices that are not yet
online. To perform this operation, the user has to know all the essential information about the
device. A series of questions will be asked to guide the user through the process. The questions
will vary based on the ‘Current’ map protocol. The user will be asked to select the LUN
address for a device, then the protocol/port on which device will reside, then the Name for the
device (which can be left empty), then the type of device:
Figure 7-26. Creating an entry for FCP port map
Enter desired lun address > 1
Select Protocol (0 - SCSI, X=Cancel) > 0
Select SCSI Port Number:
Port#= ? (0-1, X=Cancel) and Enter
Enter desired Device Name (could be empty) >
DISK_DEVICE - 0, TAPE_DEVICE - 1
PRINTER_DEVICE - 2, PROCESSOR_DEVICE - 3
WORM_DEVICE - 4, CDROM_DEVICE - 5
SCANNER_DEVICE - 6, OPTICAL_DEVICE - 7
MEDIUM_CHGR_DEVICE - 8, COMM_DEVICE - 9
ARRAY_CTLR_DEVICE - 12, ENCLOSURE_SRV_DEVICE - 13
Enter desired Device Type > 1
Enter device target id > 5
Enter device lun id > 0
Note: If the device being added is a SCSI device, the user will also be asked
to enter Target ID and LUN ID for the device. Target ID must already be
defined in the SCSI Configuration. Otherwise, adding a device will not be
permitted.
Note: When creating a device that does not exist, it will be displayed with
‘Down’ status.