Virtual TapeServer SCSI-to-FC Adapter User Manual

7-28
Chapter 7: Using the Serial/Telnet Interface
Remove Gaps
This option removes any incremental gaps in the sequence of LUNs listed in the table.
Deleting an Entry
The user selects a LUN ID.
Figure 7-27. Deleting an entry
Select D to delete multiple LUNs:
Figure 7-28. Deleting multiple LUNs
• Select 3 from the Map Edit Menu to clear (i.e. remove all entries from) the current map. The
user is prompted for confirmation.
Figure 7-29. Clear all entries from current map
• Select 4 from the Map Edit Menu to fill the current map. Then select the fill priority: B=Bus/
Target, T=Target/Bus, X=Cancel. This selection scans the device list and appends all
Select LUN to delete (X=Cancel, D=DeleteMulitple) > 0
Are you sure you want to delete LUN 0? (Y=Confirm, X=Cancel) > y
Select LUN to delete (X=Cancel, D=DeleteMulitple) > d
Enter comma delimited LUNs to delete > 0, 1, 4
Are you sure you want to delete LUN 0? (Y=Confirm, X=Cancel) > y
Are you sure you want to delete LUN 1? (Y=Confirm, X=Cancel) > y
Are you sure you want to delete LUN 4? (Y=Confirm, X=Cancel) > y
Note: When deleting multiple LUNs, the user can list the LUNs to delete in
a comma or space delimited format.
This will clear all entries from SCSI map 'Default' on Port 0.
Are you sure (Y=Confirm, X=Cancel) > y
SCSI map 'Indexed' on Port 0 was cleared.