Virtual TapeServer SCSI-to-FC Adapter User Manual

7-30
Chapter 7: Using the Serial/Telnet Interface
The following is an example of a host list for FCP hosts:
Figure 7-31. Host list for FCP hosts
Adding a Host
Select ‘A’ to add a host to the list. The user will be prompted to enter the desired Host Name,
Host ID, Port WWN and Node WWN for FCP host. WWN values are hexadecimal. If the user
doesn’t know the Host ID, the host won’t be added to the host list. Duplicate hosts won’t be
added to the list.
Host List Edit Display
X.X.XX XXXXXX XXXXXX-XXX_XXXXXXXXXXXXXX
01/07/2010 10:31:55
Current Map: FCP Port 0 - Name 'Indexed'
FCP Port# 0 Host List:
+----+---------------+---------------+-------------------++-----------------+
| N# | Port WWN | Node WWN | Host Name || Active Map Name |
+----+---------------+---------------+-------------------++-----------------+
| 1 | Hi 0x210000E0 | Hi 0x200000E0 | (built at runtime)|| Auto Assigned |
| | Lo 0x8B02C20E | Lo 0x8B02C20E | PortID = 0x0000EF || |
+----+---------------+---------------+-------------------++-----------------+
Page # 1 out of 1 pages.
Total Number of Hosts = 1
Select Host Number(1 - 1) to associate host with the Current Map
Enter (N=Next, P=Prev, A=Add, D=Delete, E=Edit, X=Exit) >
Note: Because the entire list of hosts may not fit on one screen, select ‘N’
or ‘P’ to see any additional pages showing the list of hosts. Select ‘X’ to
return to the ‘Device Mapping Main Menu’. Select number from the
column on the left to associate host with the ‘Current’ map. At this point
the user can edit, delete, or change name for the host.