Virtual TapeServer SCSI-to-FC Adapter User Manual

7-31
Chapter 7: Using the Serial/Telnet Interface
Figure 7-32. Adding a FCP host
Following the successful addition of the host, the host list will be displayed again and the user
can make sure that the host information is correct.
Deleting a Host
Select ‘D’ to delete a host from the host list. The operator will be asked to enter an index for
the host that is displayed in the very left column of the table, and asked for confirmation.
Figure 7-33. Deleting a host
Editing a Host
Select ‘E’ to edit host information. Old information will be displayed on the screen, and the
user will be asked to enter information to replace it, or just hit Enter to keep old information.
All of the information entered by the user will be validated.
The following is an example of editing a host list for an FCP Port:
Enter desired Host Name > Fcp Host
Do you know Port ID of the Host?(y/n) > y
Enter Host ID of the host > 0000ef
Enter the new host's Port WWN High > 210000E0
Enter the new host's Port WWN Low > 8B02C20E
Enter the new host's Node WWN High > 200000E0
Enter the new host's Node WWN Low > 8B02C20E
Host was successfully added to the host list!!!
Select Host to delete (X=Cancel) > 1
Are you sure you want to permanently remove Host 1? (Y=Confirm,
X=Cancel) > y