Virtual TapeServer SCSI-to-FC Adapter User Manual

7-33
Chapter 7: Using the Serial/Telnet Interface
Figure 7-35. Entire device list
• Select 9 from the Device Mapping menu to activate port mapping changes.
Entire Device List
X.X.XX XXXXXX XXXXXX-XXX_XXXXXXXXXXXXXX
01/07/2010 10:31:55
+----++------+------+------+------+--------------------------------+-------+
| N# || Prtl | Port | TYPE | STAT | Protocol Specific Information |Map Cnt|
+----++------+------+------+------+--------------------------------+-------+
| 1 || SCSI | 1 | TAPE | UP | Target= 3 Lun= 0 | 2 |
| 2 || SCSI | 1 | DISK | UP | Target= 4 Lun= 0 | 2 |
| 3 || SCSI | 1 | DISK | UP | Target= 5 Lun= 0 | 2 |
| 4 || SCSI | 1 | DISK | UP | Target= 6 Lun= 0 | 2 |
| 5 || SCSI | 2 | TAPE | DOWN | Target= 5 Lun= 0 | 1 |
| 6 || SCSI | 5 | TAPE | UP | Target= 1 Lun= 0 | 2 |
| 7 || SCSI | 5 | DISK | UP | Target= 2 Lun= 0 | 2 |
| 8 || FCP | 0 | DISK | DOWN | WWN= 0x1545210015326500 Lun= 0| 1 |
| 9 || FCP | 1 | DISK | UP | WWN= 0x22000020374F9BB7 Lun= 0| 1 |
| 10 || FCP | 1 | DISK | UP | WWN= 0x500507650543E065 Lun= 0| 1 |
+----++------+------+------+------+--------------------------------+-------+
Page # 1 out of 1 pages.
Number of entries in the device table = 10
Enter(N=Next, P=Prev, X=Exit) >
Caution: Before activating any port mapping changes, it is strongly
recommended that the user verify there are not any command or data
operations occurring in conjunction with devices affected by the mapping
changes. For example, deleting a LUN or device from a map may disrupt I/
O transfers with that device. It is the user’s responsibility to ensure that no
operations will be negatively impacted due to the activation of mapping
changes.
Note: All current Mapping Settings will take effect immediately! If another
management interface has made unsaved mapping changes, those changes
will be lost.