Virtual TapeServer SCSI-to-FC Adapter User Manual

7-42
Chapter 7: Using the Serial/Telnet Interface
Restore Last Saved Configuration
This option restores the most recently saved configuration. This can be useful when configuration
changes are made, but the user wishes to return to the previously saved configured state. The
changes take effect after the VT5900-SA has rebooted.
Reset to Factory Defaults
This option resets all current configuration options to the factory defaults and saves those options
to FLASH memory as the current configuration. The changes take effect after the VT5900-SA has
rebooted.
Buffer Memory Integrity Test Configuration
This option enables you to view the current interval for the buffre test, set the interval, and initiate
a buffer test.
System Utilities
Figure 7-44. System utility menu
• Select 1 to display the System Statistics Menu, described later in this chapter.
• Select 2 to display the Event Log Menu, described later in this chapter.
• Select 3 to save a report to file, described later in this chapter.
• Select 4 to enter diagnostics mode. (This option is available only through a serial connection,
not a telnet connection.) A confirmation message will appear verifying you want to do this. If
System Utility Menu
X.X.XX XXXXXX XXXXXX-XXX_XXXXXXXXXXXXXX
01/07/2010 10:31:55
1) System Statistics Menu
2) Event Log
3) Runtime Report
4) Enter System Diagnostics Mode
5) Special Fibre Channel Link States
6) SCSI Command Tracking
7) Active Initiators, Device Entries, and Host Stats
X) Return to main menu