Virtual TapeServer SCSI-to-FC Adapter User Manual

7-43
Chapter 7: Using the Serial/Telnet Interface
you enter N for No, you are returned to the System Utilities menu. If you enter Y for Yes, the
VT5900-SA enters System Diagnostics Mode. This option is described in more detail later in
this chapter.
• Select 5 to access a special diagnostic utility. (This option is available only through a serial
connection, not a telnet connection.) This utility should not be used unless under the guidance
of an authorized HP technician.
• Select 6 to display the SCSI Command Tracking menu, described later in this chapter.
• Select 7 to display the active initiators and device entries, described later in this chapter.
System Statistics
Figure 7-45. System status/statistics menu
• Select 1 from the System Status/Statistics Menu to display system status.
Figure 7-46. System status menu
– Select 1 from the System Status Menu to display memory statistics.
System Status/Statistics Menu
X.X.XX XXXXXX XXXXXX-XXX_XXXXXXXXXXXXXX
01/07/2010 10:31:55
1) Display System Status
2) Display Fibre Channel Protocol Status
3) Display Parallel SCSI Protocol Status
X) Return to main menu
System Status Menu
X.X.XX XXXXXX XXXXXX-XXX_XXXXXXXXXXXXXX
01/07/2010 10:31:55
1) Display memory statistics
2) Display active tasks
3) Display stack usage
4) Display SCSI Protocol Resources
5) Display Ethernet Resources
X) Return to previous menu