Virtual TapeServer SCSI-to-FC Adapter User Manual

F-4
Appendix F: Enabling DHCP on the VT5900-SA
• Select: 2. The following menu appears:
Figure F-3: Ethernet configuration menu
Select 7 to toggle the DHCP setting. When DHCP is enabled, this activates Dynamic Host
Configuration Protocol and allows the VT5900-SA to be assigned a dynamic IP address from a
DHCP server located on the Ethernet network used by the VT5900-SA.
For descriptions of other menu selections, refer to Chapter 5.
Once DHCP is enabled, it is necessary to save the current configuration and reboot the VT5900-
SA before DHCP will operate.
Ethernet Configuration Menu
X.X.XX XXXXXX XXXXXX-XXX_XXXXXXXXXXXXXX
01/06/2006 08:56:22
IP Address : 1.1.1.1
Subnet Mask : 255.255.255.0
IP Gateway : 0.0.0.0
Ethernet Physical Address : 08:06:07:05:03:09
Ethernet Mode : 10/100Mbps (Auto-Neg)
Hostname :
DHCP Configuration : Disabled
1) Change IP Address
2) Change IP Subnet Mask
3) Change IP Gateway
4) Change Ethernet Physical Address
5) Toggle Ethernet Mode
6) Change Hostname
7) Toggle DHCP Configuration
8) Change SNMP Settings
9) Change Security Settings
X) Return to previous menu
Note: For the IP address, Subnet Mask, and IP Gateway address, it is okay to have null values
prior to rebooting the VT5900-SA. However, if these settings have null values after a reboot,
then this indicates the DHCP Server was unable to acquire the information for that setting. See
special note below for more information.