Virtual TapeServer SCSI-to-FC Adapter User Manual

F-6
Appendix F: Enabling DHCP on the VT5900-SA
Special Note Regarding Ethernet IP, Subnet Mask, and Gateway
Addresses
Once DHCP is enabled, any “null” readings are acceptable for these 3 options before reboot. Also,
the Ethernet Configuration Menu will not allow for changing these 3 options (since they are
automatically configured by DHCP). As a result, the Ethernet Configuration Menu will display
without these options listed. Here’s an example of this “DHCP-enabled” menu. Do not use the
following options, as they will display an error message: 1) Change IP Address, 2) Change IP
Subnet Mask, and 3) Change IP Gateway.
Figure F-4: Ethernet configuration menu
Ethernet Configuration Menu
X.X.XX XXXXXX XXXXXX-XXX_XXXXXXXXXXXXXX
01/06/2006 08:56:22
IP Address : 1.1.1.1
Subnet Mask : 255.255.255.0
IP Gateway : 0.0.0.0
Ethernet Physical Address : 08:06:07:05:03:09
Ethernet Mode : 10/100Mbps (Auto-Neg)
Hostname :
DHCP Configuration : ENABLED
1) Change IP Address
2) Change IP Subnet Mask
3) Change IP Gateway
4) Change Ethernet Physical Address
5) Toggle Ethernet Mode
6) Change Hostname
7) Toggle DHCP Configuration
8) Change SNMP Settings
9) Change Security Settings
X) Return to previous menu