Virtual TapeServer SCSI-to-FC Adapter User Manual

3-3
Chapter 3: Configuration Procedures
4. To enable remote management capabilities, change the Ethernet settings to “DHCP enabled”
or enter a valid IP address and IP gateway so the VT5900-SA is configured properly for
network operation. Select menu option 2 from the configuration menu to access Ethernet
settings.
5. Select the letter A to save your configuration changes to the VT5900-SA. Once the VT5900-
SA saves your configuration changes, enter X to exit to the Main menu.
6. Select menu option 4 to reboot the VT5900-SA. In about 30 seconds, the VT5900-SA will
once again display the main menu.
7. If the VT5900-SA does not see all of the devices expected, repeat steps 4-6 above, and check
that the initiator ID(s) are set to a unique value for the selected bus. To change the Initiator ID,
select the appropriate SCSI bus and then select a SCSI ID that is not in use by any device(s)
attached to the VT5900-SA. Again, you must save any changes and reboot the VT5900-SA.
You have now successfully configured the VT5900-SA. This procedure may not apply to all
situations but does address most key issues required for initial setup.