Virtual TapeServer SCSI-to-FC Adapter User Manual

6-25
Chapter 6: Using Visual Manager
The following shows the dialog box that appears for the FC Port when the Select Host Edit/View
button is selected.
Figure 6-22. Select Host for FC Port
The current host information is shown at the top of the dialog box. This information can be
changed in the Modify FC Host section.
• New or updated information can be typed into the field boxes for Host Name, Host Id (in
Hex), Port WWN Hi (in Hex), Port WWN Lo (in Hex), Node WWN Hi (in Hex), or Node
WWN Lo (in Hex).
• The Map Name can be selected from the drop-down list.
• To make the changes permanent, select the Modify button.
The following shows the dialog box that appears for the FC Port when the Select Map Edit/View
button is selected.
Note: All current Mapping Settings will take effect immediately! If another management
interface has made unsaved mapping changes, those changes will be lost.
Note: It the Activate Mapping Changes button is not selected, the mapping changes will
not take effect unless the VT5900-SA is rebooted.
Note: Host settings are saved to memory when the Modify button is selected but are not
activated until either the Activate Mapping Changes button is selected or the VT5900-SA is
rebooted.