Virtual TapeServer SCSI-to-FC Adapter User Manual

7-2
Chapter 7: Using the Serial/Telnet Interface
Figure 7-1. Power up messages
Router 5.9\5.9.61
CPU Program RAM : 02000000
PCI Protocol RAM : 02000000
SCSI Script RAM (0) : 00002000
SCSI Script RAM (1) : 00002000
---Router Reboot via firmware---
Ethernet POST Test : PASSED
SCSI POST Test (0) : PASSED
SCSI POST Test (1) : PASSED
Fibre Channel POST(0): PASSED
Target Name: Generic
User: target
Attaching network interface lnPci0... done.
Attached TCP/IP interface to lnPci unit 0
Attaching network interface lo0... done.
NFS client support not included.
Contacting DHCP server for lnPci0...done.
---Enter routerInit---
---Calling cfgMgrInit()---
---Starting start_router---
---Starting SCSI - 2 ports
SCSI bus 0 is up. Connect Mode: (Differential)
SCSI Controller is an 896 Terminators On
SCSI bus 1 is up. Connect Mode: (Differential)
SCSI Controller is an 896 Terminators On
Doing oem init: HP Code
---Finished start_router---
Note: The illustrations in this chapter use Xs to represent numeric values for
certain data fields, such as the product release version and the revision of
firmware.
Note: For the serial interface, if you do not see messages on your screen, you
may need to re-check your computer’s serial port settings and press Enter five
or six times.