Visual Image Package Installation Instructions

Visual Image Package Instructions Read Me—524411-001

Visual Image Package

Installation Instructions

These instructions describe how to replace the short system enclosure doors with tall

system enclosure doors and how to install the side panels. You need a Phillips

screwdriver and T-25 Torx screwdriver. There are two kits:

•

The 7285 full-upgrade kit contains two doors and two side panels.

•

The 7286 partial-upgrade kit contains two doors.

Install the Service-Side Door

1. Unpack an upgrade kit and verify that all items are present. Both upgrade kits

contain these items for installing doors:

A tall, service-side door

An adapter frame for the service-side door

A tall, appearance-side door

Group ID labels

4 M5 Phillips screws

4 M5 KEP nuts

4-mm hex-key wrench

The 7285 full-upgrade kit also contains the components listed in Step 1 under

Install the Side Panels on page 2.

2. If you are replacing the service-side door, remove and discard the existing door

from the service side of the enclosure and go to Step 5.

3. Position the adapter frame on the enclosure:

a. Position the adapter frame on the outside of the cable channel frame.

b. Align the mounting hooks on the adapter frame with the enlarged holes near

the top of the cable channel frame.

c. Push the adapter frame in and down so that the mounting hooks engage and

support the adapter frame.

d. Verify that the adapter frame is flush against the cable channel frame and that

the screw holes are aligned.

4. Install 4 M5 Phillips screws and 4 M5 KEP nuts on the adapter frame:

a. Insert a Phillips screwdriver through an access hole in the adapter frame.

b. Use the screwdriver to insert a Phillips screw in the screw hole.

c. Hold the screw in position using the screwdriver, and from the inside of the

cable channel, install a KEP nut on the end of the screw.

d. Holding the KEP nut, tighten the screw, and then back off the screw 1/4 turn.

e. Install the remaining screws and KEP nuts in the same way, and then fully

tighten the screws.

PAGE 1
Visual Image Package Installation Instructions These instructions describe how to replace the short system enclosure doors with tall system enclosure doors and how to install the side panels. You need a Phillips screwdriver and T-25 Torx screwdriver. There are two kits: • • The 7285 full-upgrade kit contains two doors and two side panels. The 7286 partial-upgrade kit contains two doors. Install the Service-Side Door 1. Unpack an upgrade kit and verify that all items are present.
PAGE 2
Visual Image Package Installation Instructions Install the Appearance-Side Door 5. Install the service-side door on the enclosure: a. b. c. d. e. With both hands, lift the door into position against the adapter frame. Align the hinge pins on the door with the holes in the enclosure bracket. Insert the top (long) hinge pin first, then insert the bottom hinge pin. Lower the door and engage the hinges. Close the door to check that it is correctly installed. 6. Install the group ID label on the door: a.
PAGE 3
Install the Side Panels Visual Image Package Installation Instructions b. Insert 2 Phillips screws through the bottom screw holes on the bracket into the bottom row of perforations. Bottom Screw Hole c. Insert 2 more Phillips screws into the remaining bracket holes. d. Install one small bracket near the bottom of the enclosure side, using the 2 existing M5 Torx screws already installed on the enclosure. M5 Torx Screw 3.