WAN Manager SPI Programming Guide

WAN Manager Commands and Responses
WAN Manager SPI Programming Guide—540013-001
5-70
START PROCESS
SCF Example
START PATH $ZZWAN.#S13.1.*
START PROCESS
This command places a process in the STARTED state.
The START PROCESS command has this syntax:
cpu-num
is the processor number where the ConMgr object normally executes. You can also
use wild cards such as an asterisk (*) or question mark (?) in any combination (for
example, $ZZWAN.#?, $ZZWAN.#*, and so on).
proc-name
is the name of process other than ConMgr. You can also use wild cards such as an
asterisk (*) or question mark (?), in any combination (for example, $ZZWAN.#?,
$ZZWAN.#*, and so on).
SCF Example
START PROCESS $ZZWAN.#*
Tokens in Command Buffer
ZSPI-TKN-COMMAND: ZCOM-CMD-START
ZSPI-TKN-OBJECT-TYPE: ZCOM-OBJ-PATH
ZCOM-TKN-OBJNAME: $ZZWAN.#conc-name.clip-num.{ A | B }
Tokens in Response Buffer
ZSPI-TKN-DATALIST:*
ZCOM-TKN-OBJNAME: $ZZWAN.#conc-name.clip-num.{ A | B }
ZCOM-TKN-OBJTYPE: ZCOM-OBJ-PATH
ZSPI-TKN-RETCODE: ZCOM-ERR-OK
ZSPI-TKN-ENDLIST:-
START PROCESS $ZZWAN.#{ cpu-num | proc-name }
Note. Do not configure the SNMP trap multiplexer, TFTP, or WANBoot processes. From
G06.13, these processes are automatically configured and started when the first ADAPTER
object is added to the SUBNET.
Tokens in Command Buffer
ZSPI-TKN-COMMAND: ZCOM-CMD-START
ZSPI-TKN-OBJECT-TYPE: ZCOM-OBJ-PROC
ZCOM-TKN-OBJNAME: $ZZWAN.#{ cpu-num | proc-name }