WAN Subsystem Configuration and Management Manual

Adding a SWAN Concentrator
WAN Subsystem Configuration and Management Manual—522463-011
4-20
Configuring and Starting the SWAN Concentrator
Objects
track-ID is located on the rear panel of each SWAN concentrator (For more
information, see Figure 4-4 on page 4-10 and Figure 4-5 on page 4-10).
tcpip-name
indicates the name of the preferred TCP/IP process that supports the SWAN
concentrator. The name of this TCP/IP process should appear on your SWAN
Concentrator Configuration-Planning Forms on page 4-11.
ip-address
indicates the IP address assigned to a SUBNET on the preferred TCP/IP process
(specified in the TCP/IP attribute).
router-ip-address
indicates the SWAN-side router IP address for Path A. A gateway IP address of 0
(0.0.0.0) indicates that the SWAN concentrator is on the same network as the host.
alt-router-ip-address
indicates the alternate SWAN-side router IP address for Path B. A gateway IP
address of 0 (0.0.0.0) indicates that the SWAN concentrator is on the same
network as the host.
alt-tcpip-name
indicates the name of the alternate TCP/IP process that supports the SWAN
concentrator. The name of this TCP/IP process should appear on your SWAN
Concentrator Configuration-Planning Forms on page 4-11.
alt-ip-address
indicates the IP address assigned to a SUBNET on the alternate TCP/IP process
(specified in the ALTTCPIP attribute).
SNMPCODE $SYSTEM.CSSnn.C7849P00
indicates the name of the object file of the SNMP agent process that you want to
run in the CLIP.
This attribute is optional for both SWAN and SWAN 2 concentrators because the
SNMP module is linked with the SWAN NonStop Kernel (in G06.07 and later
RVUs) and does not have to be downloaded.
Note. The value for the TRACKID is case-sensitive. If you specify the value incorrectly,
you cannot use the SWAN concentrator because the WAN subsystem and the OSM or
TSM discovery process will not find the SWAN concentrator when it is powered on.