WAN Subsystem Configuration and Management Manual

SCF Commands
WAN Subsystem Configuration and Management Manual—522463-011
6-7
ABORT Command
ABORT Command
ABORT is a sensitive command that is used to terminate the operation of a WAN
subsystem object as quickly as possible. Only enough processing is done to ensure
that the object can run again when it is restarted.
ABORT ADAPTER Command
Use the ABORT ADAPTER command to terminate the operation of all CLIPs on a
SWAN concentrator. The ABORT ADAPTER command places the ADAPTER object in
the STOPPED state, which prevents further use of the CLIPs on the SWAN
concentrator.
The ABORT ADAPTER command has this syntax:
conc-name
indicates the name of the SWAN concentrator.
SEL [ NOT ] sumstate
directs the command only at objects in the specified state or only at those not in
the specified state.
SUB { ALL | NONE | ONLY }
selects the subordinate objects the command affects.
ALL
specifies that the named object and the subordinate objects are affected.
NONE
specifies that the named object is affected but that the subordinate objects are
not. NONE is the default.
ABORT ADAPTER $ZZWAN.#conc-name
[ , SEL [ NOT ] sumstate ]
[ , SUB { ALL | NONE | ONLY } ]
Value: The name of the ADAPTER object as specified in the ADD
ADAPTER command.
Default: None provided.
Wild card: You can use the asterisk (*) to specify all configured
ADAPTER objects.
Value: Valid states are STARTED, STARTING, STOPPED, and STOPPING.
Default: None provided.