WAN Subsystem Configuration and Management Manual

SCF Commands

WAN Subsystem Configuration and Management Manual—522463-011

6-11

ABORT SERVER Command

Use the ABORT SERVER command to terminate the operation of a CLIP. The ABORT

SERVER command places the SERVER object in the STOPPED state, which prevents

further use of the CLIP.

The ABORT SERVER command has this syntax:

conc-name.clip-num

indicates a CLIP.

SEL [ NOT ] sumstate

directs the command only at objects in the specified state or only at those not in

the specified state.

SUB { ALL | NONE | ONLY }

selects the subordinate objects the command affects.

ALL

specifies that the named object and the subordinate objects are affected.

NONE

specifies that the named object is affected but that the subordinate objects are

not. NONE is the default.

ABORT SERVER $ZZWAN.#conc-name.clip-num

[ , SEL [ NOT ] sumstate ]

[ , SUB { ALL | NONE | ONLY } ]

Value: The SERVER name is the name of the SWAN concentrator,

followed by the CLIP number.

conc-name is the name of the SWAN concentrator as specified in

the ADD ADAPTER command.

clip-num is the CLIP number. The possible values for the CLIP

number are 1, 2, or 3 for a SWAN concentrator and 1, 2, 3, 4, 5, or

6 for a SWAN 2 concentrator.

Default: None provided.

Wild card: You can use the asterisk (*) to specify all configured SERVER

objects.

Value: Valid states are STARTED, STARTING, STOPPED, and STOPPING.

Default: None provided.