WAN Subsystem Configuration and Management Manual

SCF Commands
WAN Subsystem Configuration and Management Manual—522463-011
6-15
ADD ADAPTER Command
address portion of an IP address is subdivided into a subnet number that identifies
a particular subnet and a host number that identifies a host within the subnet.
To determine a subnet mask, use the INFO SUBNET command as shown in
Example 6-2. The hexadecimal value of the subnet mask is shown in boldface
type.
ALTTCPIP alt-tcpip-name
indicates the name of the alternate TCP/IP process that supports the SWAN
concentrator.
GATEWAYIP router-ip-address
indicates the SWAN-side router IP address for Path A. A gateway IP address of 0
(0.0.0.0) indicates the SWAN concentrator is on the same network as the host.
Value: An IP address is a 4-octet (32-bit) numeric value. It is specified in
dotted decimal notation, which represents 4 octets in ASCII,
separated by periods; for example, 133.50.85.43. Each octet value is
a number in the range 0 through 255.
Default: None provided.
Example 6-2. Finding a Subnet Mask
3-> info subnet $zb01d.*
TCP/IP Info SUBNET \MYSYS.$ZB01D.*
Name Devicename *IPADDRESS TYPE *SUBNETMASK SuName QIO *R
#LOOP0 \NOSYS.$NOIOP 127.0.0.1 LOOP-BACK %HFF000000 OFF N
#SN1 \MYSYS.L01D 172.16.40.26 ETHERNET %HFFFFFF00 ON N
Value: The name of the TCP/IP process as configured in the TCP/IP
subsystem SCF ADD PROCESS command.
Default: None provided.
Value: An IP address is a 4-octet (32-bit) numeric value. It is specified in
dotted decimal notation, which represents 4 octets in ASCII,
separated by periods; for example, 133.50.85.43. Each octet value is
a number in the range 0 through 255.
Default: 0 (0.0.0.0.)