WAN Subsystem Configuration and Management Manual

SCF Commands
WAN Subsystem Configuration and Management Manual—522463-011
6-24
ADD PROCESS Command
Considerations
•
The SWAN concentrator must have been previously defined with the ADD
ADAPTER and ADD SERVER commands. Add the PATH object with the ADD
PATH command. The PATH object is defined and is placed in the STOPPED state.
•
You must issue the ADD PATH command six times to configure both Ethernet
paths on all three CLIPs on one SWAN concentrator.
•
You must issue a START PATH command before you can use the Ethernet path.
ADD PROCESS Command
Use the ADD PROCESS command to define a ConMgr process to the configuration
database.
ConMgr Process Syntax
The ADD PROCESS command has this syntax for a ConMgr process:
cpu-num
indicates the name of the ConMgr process by specifying the processor in which the
ConMgr process is to run. The WAN subsystem names the ConMgr process
$ZZWAN.#nn where nn is the processor number.
Note. Do not configure the SNMP trap multiplexer, TFTP, or WANBoot processes. These
processes are automatically configured and started when a new ADAPTER object is added.
ADD PROCESS $ZZWAN.#cpu-num
, IOPOBJECT object-file-name
Value: The possible values are 0 through n.
The ConMgr process name, when displayed from the WAN
subsystem INFO command, is $ZZWAN.#0 for the ConMgr
process configured to run in processor 0, $ZZWAN.#1 for the
ConMgr process configured to run in processor 1, and so on.
The ConMgr process name, when displayed from a TACL STATUS
command, is $ZZW00 for the ConMgr process configured to run in
processor 0, $ZZW01 for the ConMgr process configured to run in
processor 1, and so on.
Default: None provided.