WAN Subsystem Configuration and Management Manual

SCF Commands
WAN Subsystem Configuration and Management Manual—522463-011
6-29
ALTER ADAPTER Command
The ALTER ADAPTER command has this syntax (you must specify one or more
attributes):
conc-name
indicates the name of the SWAN concentrator. The SWAN concentrator name
should follow the naming conventions described in HP Manufacturing Naming
Conventions (G06.26 and Earlier RVUs) on page 1-3 or HP Manufacturing Naming
Conventions (G06.27 and Later RVUs and H06.03 and Later RVUs) on page 1-7.
.
ALTGATEWAYIP alt-router-ip-address
indicates the alternate SWAN-side router IP address for Path B. A gateway IP
address of 0 (0.0.0.0) indicates that the SWAN concentrator is on the same
network as the host.
ALTER ADAPTER $ZZWAN.#conc-name
[ , ALTGATEWAYIP alt-router-ip-address ]
[ , ALTHOSTIP alt-ip-address ]
[ , ALTSUBNETMASK alt-subnet-mask ]
[ , ALTTCPIP alt-tcpip-name ]
[ , GATEWAYIP router-ip-address ]
[ , HOSTIP ip-address ]
[ , KERNELCODE swan-kernel-micode-file-name ]
[ , SNMPCODE swan-snmp-agent-micode-file-name ]
[ , SUBNETMASK subnet-mask ]
[ , TCP/IP tcpip-name ]
[ , TRACKID "configuration-track-id" ]
[ , TYPE type-name ]
Value: The name of the SWAN concentrator as specified in the ADD
ADAPTER command.
Default: None provided.
Value: An IP address is a 4-octet (32-bit) numeric value. It is specified in
dotted decimal notation, which represents 4 octets in ASCII,
separated by periods; for example, 133.50.85.43. Each octet value is
a number in the range 0 through 255.
Default: 0 (0.0.0.0.).