WAN Subsystem Configuration and Management Manual

SCF Commands
WAN Subsystem Configuration and Management Manual—522463-011
6-36
ALTER PATH Command
RESET [ ( modifier-keyword [ modifier-keyword ... ] ) ]
resets the specified modifier (or modifiers) back to its default value. The
parenthesis are required if more than one modifier is specified. If no modifiers are
specified, then all modifiers are reset to their default values.
TYPE type , sub-type
indicates the NonStop Kernel registered type and subtype for the DEVICE object.
Considerations
•
You must stop the DEVICE object by using the STOP DEVICE command before
you can the object.
•
You must issue a START DEVICE command to start the DEVICE object, which
must start the data communications subsystem object before you can use it.
ALTER PATH Command
Use the ALTER PATH command to change the IP address of an existing path. The
ALTER PATH command changes only the IP address of the target PATH object.
The ALTER PATH command has this syntax:
Value: DEVICE object types and subtypes for data communications sub-
system objects are described in the manuals listed in Table 6-4 on
page 6-21.
Default: None provided.
ALTER PATH $ZZWAN.#conc-name.clip-num.path-name
, IPADDRESS ip-address