WAN Subsystem Configuration and Management Manual

SCF Commands
WAN Subsystem Configuration and Management Manual—522463-011
6-38
ALTER PROCESS Command
ConMgr Process Syntax
The ALTER PROCESS command has this syntax for a ConMgr process:
cpu-num
indicates the name of the ConMgr process by specifying the processor the ConMgr
process is to run in. The WAN subsystem names the ConMgr process $ZZWAN.nn
where nn is the processor number.
IOPOBJECT object-file-name
indicates the file name of the executable object code for the ConMgr process.
SNMP Trap Multiplexer Process Syntax
The ALTER PROCESS command has this syntax for an SNMP trap multiplexer
process:
ALTER PROCESS $ZZWAN.#cpu-num
, IOPOBJECT object-file-name
Value: The possible values are 0 through n.
The ConMgr process name, when displayed from the WAN
subsystem INFO command, is $ZZWAN.#0 for the ConMgr
process configured to run in processor 0, $ZZWAN.#1 for the
ConMgr process configured to run in processor 1, and so on.
The ConMgr process name, when displayed from a TACL STATUS
command, is $ZZW00 for the ConMgr process configured to run in
processor 0, $ZZW01 for the ConMgr process configured to run in
processor 1, and so on.
Default: None provided.
Value: The object file resides (by default) at $SYSTEM.SYSnn.CONMGR.
Default: None provided.
ALTER PROCESS $ZZWAN.#process-name
[ , ALTCPU alt-cpu-num ]
[ , CPU cpu-num ]
[ , IOPOBJECT object-file-name ]
[ , HOSTIP ip-address ]
[ , TCP/IP tcpip-name ]
[ , TYPE type , sub-type ]