WAN Subsystem Configuration and Management Manual

WAN Subsystem Configuration and Management Manual—522463-011
xvii
About This Manual
The WAN Subsystem Configuration and Management Manual describes how to
configure a SWAN concentrator on an Integrity NonStop NS-series or
NonStop S-series server and includes:
•
A description of the initial WAN subsystem configuration provided by HP
manufacturing and an overview of the WAN subsystem and SWAN concentrators.
•
Basic steps for changing the initial WAN subsystem configuration provided by HP
manufacturing and for adding a SWAN concentrator to your system configuration
•
A description of the SCF interface to the WAN subsystem, including detailed
syntax information for each SCF command and SCF error messages
•
Information about upgrading to a SWAN 2 concentrator
Who Should Use This Manual
This manual is written for anyone who configures, manages, or maintains the WAN
subsystem and a SWAN concentrator.
How This Manual Is Organized
Note. Throughout this manual when a distinction between a SWAN concentrator (T3880) and
a SWAN 2 concentrator (T3881) is not required, SWAN concentrator is used as a collective
term.
Table i. Contents (page 1 of 2)
Title Contents
1 Configuration Quick Start
Describes how the WAN subsystem is initially
configured and how to verify your configuration.
2 Overview of the WAN
Subsystem
Describes the architecture of the WAN subsystem.
3 Changing the Initial WAN
Subsystem Configuration
Describes changing a WAN subsystem configuration.
4 Adding a SWAN Concentrator
Describes how to add a SWAN concentrator to your
system configuration.
5 Managing the WAN Subsystem
Describes the WAN Subsystem Control Facility (SCF)
commands used to monitor, reconfigure, and control
the WAN subsystem.
6 SCF Commands
Describes the SCF interface to the WAN subsystem.