WAN Subsystem Configuration and Management Manual

SCF Commands
WAN Subsystem Configuration and Management Manual—522463-011
6-77
NAMES PATH Command
NAMES PATH Command
Use the NAMES PATH command to display a list of the names of all configured paths
on a SWAN concentrator.
The NAMES PATH command has this syntax:
conc-name.clip-num.path-name
indicates the path name.
The format of the display for the NAMES PATH command is as follows:
PATH
shows a list of the configured PATH objects.
NAMES PATH $ZZWAN.#conc-name.clip-num.path-name
Value: The path name is the name of the SWAN concentrator, followed by
the CLIP number, followed by the path name.
conc-name is the name of the SWAN concentrator as specified in
the ADD ADAPTER command.
clip-num is the CLIP number. The possible values for the CLIP
number are 1, 2, or 3 for a SWAN concentrator and 1, 2, 3, 4, 5, or
6 for a SWAN 2 concentrator.
path-name is the name of an Ethernet path. The possible values
for the path name are A or B. A indicates the A Ethernet path. B
indicates the B Ethernet path.
Default: None provided.
Wild card: You can use the asterisk (*) to specify all configured PATH objects.
28->names path $zzwan.#s01.*.*
WANMgr Names PATH $ZZWAN.#S01.*.*
PATH
$ZZWAN.#S01.1.A
$ZZWAN.#S01.1.B
$ZZWAN.#S01.2.A
$ZZWAN.#S01.2.B
$ZZWAN.#S01.3.A
$ZZWAN.#S01.3.B