WAN Subsystem Configuration and Management Manual

SCF Commands
WAN Subsystem Configuration and Management Manual—522463-011
6-78
NAMES PROCESS Command
NAMES PROCESS Command
The NAMES PROCESS command displays a list of the names of all configured
ConMgr, SNMP trap multiplexer, TFTP server, or WANBoot processes.
The NAMES PROCESS command has this syntax:
cpu-num
indicates the name of the ConMgr process by specifying the processor the ConMgr
process is to run in. The WAN subsystem names the ConMgr process $ZZWAN.nn
where nn is the processor number.
process-name
indicates the name of the SNMP trap multiplexer, TFTP server, or WANBoot
process.
For a ConMgr process:
NAMES PROCESS $ZZWAN.#cpu-num
For an SNMP trap multiplexer, a TFTP server, or a WANBoot process:
NAMES PROCESS $ZZWAN.#process-name
Value: The possible values are 0 through n.
The ConMgr process name, when displayed from the WAN
subsystem INFO command, is $ZZWAN.#0 for the ConMgr
process configured to run in processor 0, $ZZWAN.#1 for the
ConMgr process configured to run in processor 1, and so on.
The ConMgr process name, when displayed from a TACL STATUS
command, is $ZZW00 for the ConMgr process configured to run in
processor 0, $ZZW01 for the ConMgr process configured to run in
processor 1, and so on.
Default: None provided.
Wild card: You can use the asterisk (*) to specify all configured ConMgr
processes.
Value: The name of the process as specified in the ADD PROCESS
command.
Default: None provided.
Wild card: You can use the asterisk (*) to specify all configured SNMP
trap multiplexer, TFTP server, and WANBoot processes.