WAN Subsystem Configuration and Management Manual

SCF Commands
WAN Subsystem Configuration and Management Manual—522463-011
6-85
PRIMARY Command
PRIMARY Command
PRIMARY is sensitive command that is used to change the preferred processor of the
WAN manager process. The WAN manager process must have been configured to run
as a NonStop process pair.
The PRIMARY SUBSYS command has this syntax:
CPU cpu-num
indicates the new preferred processor in which the WAN manager process is to
run.
START Command
START is a sensitive command that initiates the operation of a specified object.
START ADAPTER Command
Use the START ADAPTER command to place a SWAN concentrator in the STARTED
state. You can also use the OSM Service Connection or the TSM Service Application
(G-series RVUs only). For more information about using OSM or TSM, see the online
help within each application.
The START ADAPTER command has this syntax:
conc-name
indicates the name of the SWAN concentrator.
PRIMARY SUBSYS $ZZWAN, CPU cpu-num
Value: The possible values are 0 through n.
Default: None provided.
START ADAPTER $ZZWAN.#conc-name
[ , SUB { ALL | NONE | ONLY } ]
Value: The name of the SWAN concentrator as specified in the ADD
ADAPTER command.
Default: None provided.
Wild card: You can use the asterisk (*) to specify all configured
ADAPTER objects.