WAN Subsystem Configuration and Management Manual

SCF Commands
WAN Subsystem Configuration and Management Manual—522463-011
6-86
START DEVICE Command
SUB { ALL | NONE | ONLY }
selects the subordinate object that the command affects.
ALL
specifies that the named object and the subordinate objects are affected.
NONE
specifies that the named object is affected but that the subordinate objects are
not. NONE is the default.
ONLY
specifies that only the subordinate objects are affected.
Considerations
•
The SWAN concentrator must have been previously defined through the ADD
ADAPTER, ADD SERVER, and ADD PATH commands.
•
When starting a SWAN concentrator from a command file, you must include the
ALLOW ALL ERRORS command. To receive DIAG task errors. If you do not
include the ALLOW ALL ERRORS command, you cannot start WAN lines. When
SCF is used in interactive mode, the default is ALLOW ALL errors and warnings.
START DEVICE Command
Use the START DEVICE command to place a data-communications subsystem object
in the STARTED state.
The START DEVICE command has this syntax:
device-name
indicates the name of the DEVICE object in the configuration database and is also
the name of the corresponding data-communications subsystem object.
START DEVICE $ZZWAN.#device-name
[ , SEL [ NOT ] sumstate ]
[ , SUB { NONE } ]
Value: The name of the data-communications subsystem object as
specified in the ADD DEVICE command.
Default: None provided.
Wild card: You can use the asterisk (*) to specify all configured DEVICE
objects.