WAN Subsystem Configuration and Management Manual

SCF Commands
WAN Subsystem Configuration and Management Manual—522463-011
6-90
START PROCESS Command
The START PROCESS command has this syntax:
cpu-num
indicates the name of the ConMgr process by specifying the processor the ConMgr
process is to run in. The WAN subsystem names the ConMgr process $ZZWAN.nn
where nn is the processor number.
process-name
indicates the name of the SNMP trap multiplexer, TFTP server, or WANBoot
process.
Considerations
The START PROCESS command for the SNMP trap multiplexer, TFTP, or WANBoot
process fails on these conditions:
•
No HOSTIP is configured (HOSTIP was not provided or the WAN manager
process could not allocate it).
•
No adapter is configured.
•
Another process that uses the same HOSTIP is already configured.
For a ConMgr process:
START PROCESS $ZZWAN.#cpu-num
Value: The possible values are 0 through n.
The ConMgr process name, when displayed from the WAN
subsystem INFO command, is $ZZWAN.#0 for the ConMgr
process configured to run in processor 0, $ZZWAN.#1 for the
ConMgr process configured to run in processor 1, and so on.
The ConMgr process name, when displayed from a TACL STATUS
command, is $ZZW00 for the ConMgr process configured to run in
processor 0, $ZZW01 for the ConMgr process configured to run in
processor 1, and so on.
Default: None provided.
Wild card: You can use the asterisk (*) to specify all configured ConMgr
processes.
Value: The name of the process as specified in the ADD PROCESS
command.
Default: None provided.
Wild card: You can use the asterisk (*) to specify all configured SNMP
trap multiplexer, TFTP server, and WANBoot processes.