WAN Subsystem Configuration and Management Manual

SCF Commands
WAN Subsystem Configuration and Management Manual—522463-011
6-94
STATUS ADAPTER Command
conc-name
indicates the name of the SWAN concentrator.
SUB { ALL | NONE | ONLY }
selects the subordinate objects the command affects.
ALL
specifies that the named object and the subordinate objects are affected.
NONE
specifies that the named object is affected but that the subordinate objects are
not. NONE is the default.
ONLY
specifies that only the subordinate objects are affected.
HWSTATUS
specifies hardware status information from the ADAPTER. The HWSTATUS
attribute also provides additional information if the command detects a mismatched
type on one of the CLIPS. The HWSTATUS attribute is supported on the SWAN 2
concentrator only.
The format of the display for the STATUS ADAPTER command without the SUB option
is as follows:
Value: The name of the name of the SWAN concentrator as speci-
fied in the ADD ADAPTER command.
Default: None provided.
Wild card: You can use the asterisk (*) to specify all configured
ADAPTER objects.
Note. If an adapter is misconfigured the STATUS ADAPTER command (without the
HWSTATUS attribute) displays the real TYPE of the concentrator. This real TYPE of the
adapter is detected only after a BOOTP request after issuing START SERVER
$ZZWAN.#conc-name.clip-num.
13-> status adapter $zzwan.#s01
WAN Manager STATUS ADAPTER for ADAPTER \TAHITI.$ZZWAN.#S01
State........... STARTED
Number of clips. 3
Clip 1 status : CONFIGURED
Clip 2 status : CONFIGURED
Clip 3 status : CONFIGURED