WAN Subsystem Configuration and Management Manual

SCF Commands
WAN Subsystem Configuration and Management Manual—522463-011
6-97
STATUS ADAPTER Command
State
indicates the state of the ADAPTER object.
Number of clips
indicates how many CLIPs are configured for the specified ADAPTER object.
Clip 1 (2,3,4,5, or 6) status
indicates which CLIPS are configured for the specified ADAPTER object.
The following information is displayed for each configured CLIP:
State
indicates the state of the ADAPTER object.
Path A
indicates if PATH A is configured.
Path B
indicates if PATH B is configured.
Number of lines
indicates how many WAN lines are available for use on the CLIP.
Line............ 0
indicates the DEVICE object configured to use this WAN line. If no DEVICE is
configured, FREE is displayed.
Line............ 1
indicates the DEVICE object configured to use this WAN line. If no DEVICE is
configured, FREE is displayed.
The format of the display for the STATUS ADAPTER command with the HWSTATUS
option is as follows:
3-> status adapter $zzwan.#s01, hwstatus
Status of FAN A: OK/Fault Status of FAN B: OK/Fault
Status of Battery A: OK/Fault Status of Battery B: OK/Fault
Status of PS A: OK/Fault Status of PS B: OK/Fault
Status of LAN Path A : 10/100 Mbps, Full/Half Duplex or Fault or
PATH A IS DOWN / CABLE NOT CONNECTED
Status of LAN Path B : 10/100 Mbps, Full/Half Duplex or Fault or
PATH B IS DOWN / CABLE NOT CONNECTED
Status of POST: Successsful/Failed/Not Run
CLIP VPROC (obtained Onlne from CLIP): ,VPROC Info>