WAN Subsystem Configuration and Management Manual

SCF Commands
WAN Subsystem Configuration and Management Manual—522463-011
6-100
STATUS PROCESS Command
MEDIAADDRESS
specify this attribute to display only the media access control (MAC) address.
The format of the display for the STATUS PATH command is as follows:
STATE
indicates the state of the path.
STARTED
indicates that the path is in the STARTED state and can be used by a task.
STOPPED
indicates that the path is in the STOPPED state and cannot be used by a task.
MEDIA TYPE
indicates the SWAN concentrator is connected to an Ethernet LAN.
MEDIA ADDRESS
indicates the MAC address of the path. The MAC addresses are assigned to each
path at manufacturing time and are printed on the label on the rear panel of the
SWAN concentrator.
STATUS PROCESS Command
Use the STATUS PROCESS command to display current status and configuration
information about a ConMgr, an SNMP trap multiplexer, a TFTP server, or a WANBoot
process object.
The STATUS PROCESS command has this syntax:
9-> status path $zzwan.#s01.1.a
WAN Manager STATUS PATH for PATH \MYSYS1.$ZZWAN.#S01.1.A
State :......... STARTED
MEDIA TYPE...... ETHERNET
MEDIA ADDRESS... %H08008E004814
For a ConMgr process:
STATUS PROCESS $ZZWAN.#cpu-num
[ , TRACE ]
For an SNMP trap multiplexer, a TFTP server, or a WANBoot process:
STATUS PROCESS $ZZWAN.#process-name