WAN Subsystem Configuration and Management Manual

SCF Commands
WAN Subsystem Configuration and Management Manual—522463-011
6-101
STATUS PROCESS Command
cpu-num
indicates the name of the ConMgr process by specifying the processor the ConMgr
process is to run in. The WAN subsystem names the ConMgr process $ZZWAN.nn
where nn is the processor number.
TRACE
displays whether the ConMgr process is currently being traced.
process-name
indicates the name of the SNMP trap multiplexer, TFTP server, or WANBoot
process.
Value: The possible values are 0 through n.
The ConMgr process name, when displayed from the WAN sub-
system INFO command, is $ZZWAN.#0 for the ConMgr process
configured to run in processor 0, $ZZWAN.#1 for the ConMgr pro-
cess configured to run in processor 1, and so on.
The ConMgr process name, when displayed from a TACL STA-
TUS command, is $ZZW00 for the ConMgr process configured to
run in processor 0, $ZZW01 for the ConMgr process configured to
run in processor 1, and so on.
Default: None provided.
Wild card: You can use the asterisk (*) to specify all configured ConMgr pro-
cesses.
Value: The name of the process as specified in the ADD PROCESS
command.
Default: None provided.
Wild card: Where supported, use the asterisk (*) to specify all config-
ured SNMP trap multiplexer, TFTP server, and WANBoot pro-
cesses.