WAN Subsystem Configuration and Management Manual

SCF Commands
WAN Subsystem Configuration and Management Manual—522463-011
6-103
STATUS SERVER Command
The STATUS SERVER command has this syntax:
conc-name.clip-num
indicates the CLIP.
SUB { ALL | NONE | ONLY }
selects the subordinate objects the command affects.
ALL
specifies that the named object and the subordinate objects are affected.
NONE
specifies that the named object is affected but that the subordinate objects are
not. NONE is the default.
ONLY
specifies that only the subordinate objects are affected.
DETAIL
specifies that the display is to include additional detailed information about the
object. The detail option provides the VPROC of the CLIP firmware, status for both
paths and the last time the path status changed.
HWSTATUS
specifies hardware status information from the SERVER (CLIP). The HWSTATUS
attribute also provides additional information if the command detects a mismatched
STATUS SERVER $ZZWAN.#conc-name.clip-num
[ , SUB { ALL | NONE | ONLY } ] [ , DETAIL ] [, HWSTATUS ]
Value: The SERVER name is the name of the SWAN concentrator,
followed by the CLIP number.
conc-name is the name of the SWAN concentrator as specified in
the ADD ADAPTER command.
clip-num is the CLIP number. The possible values for the CLIP
number are 1, 2, or 3 for a SWAN concentrator and 1, 2, 3, 4, 5, or
6 for a SWAN 2 concentrator.
Default: None provided.
Wild card: You can use the asterisk (*) to specify all configured SERVER
objects.