WAN Subsystem Configuration and Management Manual

SCF Commands
WAN Subsystem Configuration and Management Manual—522463-011
6-104
STATUS SERVER Command
type on one of the CLIPS. The HWSTATUS attribute is supported on the SWAN 2
concentrator only.
The format of the display for the STATUS SERVER command is as follows:
State
indicates the state of the SERVER object.
STARTED
indicates that the SERVER is STARTED.
STOPPED
indicates that the SERVER is STOPPED.
Path A
indicates if PATH A is configured.
Path B
indicates if PATH B is configured.
Number of lines
indicates how many WAN lines are available for use on the CLIP.
Line............ 0
indicates the DEVICE object configured to use this WAN line. If no DEVICE is
configured, then FREE is displayed.
Line............ 1
indicates the DEVICE object configured to use this WAN line. If no DEVICE is
configured, then FREE is displayed.
15-> status server $zzwan.#s01.1
WAN Manager STATUS SERVER for CLIP \MYSYS1.$ZZWAN.#S01.1
State :......... STARTED
Path A..........: CONFIGURED
Path B..........: CONFIGURED
Number of lines. 2
Line............ 0 : $SAT23A
Line............ 1 : $SAT23B