WAN Subsystem Configuration and Management Manual

SCF Commands
WAN Subsystem Configuration and Management Manual—522463-011
6-108
STOP Command
CLIP Program
indicates the download task file used by the IOP for creating the task.
Program Timestamp
indicates the program/binder timestamp for the download task file.
STOP Command
STOP is a sensitive command that is used to halt the operation of a specified object in
an orderly manner.
STOP ADAPTER Command
Use the STOP ADAPTER command to prevent the use of all three CLIPs on a SWAN
concentrator. You can also use the OSM Service Connection or the TSM Service
Application (G-series RVUs only). For more information about using OSM or TSM,
refer to the online help within each application.
The STOP ADAPTER command places the ADAPTER object in the STOPPED state,
preventing further use of the CLIPs on the SWAN concentrator.
The STOP ADAPTER command has this syntax:
conc-name
indicates the name of the SWAN concentrator.
specifies that the named object and the subordinate objects are affected.
SUB { ALL | NONE | ONLY }
selects the subordinate objects the command affects.
ALL
specifies that the named object and the subordinate objects are affected.
STOP ADAPTER $ZZWAN.#conc-name
[ , SUB { ALL | NONE | ONLY } ]
Value: The name of the SWAN concentrator as specified in the ADD
ADAPTER command.
Default: None provided.
Wild card: You can use the asterisk (*) to specify all configured
ADAPTER objects.