WAN Subsystem Configuration and Management Manual

WAN Subsystem Configuration and Management Manual—522463-011
A-1
A SCF Messages
This appendix describes the types of Subsystem Control Facility (SCF) errors that
apply to the WAN subsystem. Messages with positive error numbers are generated by
the WAN subsystem. Messages with negative numbers are general SCF messages.
Messages without error numbers are generated during command parsing and are
generally self-explanatory.
WAN 00001
Cause. The WAN manager process had an internal error. This error might have
occurred due to a file operation in the configuration file or a pointer inconsistency in
internal data structures.
Effect. The command has no effect. A pointer inconsistency could lead to other
problems, however.
Recovery. No recovery is necessary.
WAN 00002
Cause. A command was issued to a DIAG task. None of the WAN SCF subsystem
commands apply to the DIAG task. The DIAG task is only used by OSM and TSM
(G-series RVUs only).
Effect. The command has no effect.
Recovery. No recovery is necessary. However, do not issue WAN SCF commands to
a DIAG task.
Note. Throughout this manual when a distinction between a SWAN concentrator (T3880) and
a SWAN 2 concentrator (T3881) is not required, SWAN concentrator is used as a collective
term.
Note. Messages related to the WAN manager process are issued by the NonStop Kernel sub-
system. For more information on these messages, see the SCF Reference Manual for the Ker-
nel Subsystem.
00001 WAN manager process internal error
00002 Command is not valid for DIAG TASK