WAN Subsystem Configuration and Management Manual

SCF Messages
WAN Subsystem Configuration and Management Manual—522463-011
A-5
Recovery. Reissue the command with a unique attribute name and value
combination. You can use the appropriate INFO command to determine which object is
using the specified attribute name and value combination.
If this error occurred after you added the TRACKID attribute, examine the label on the
rear panel of the SWAN concentrator to verify that you are using the correct value for
the configuration track-ID (For more information, see SWAN Concentrator Label,
Configuration Track-ID on page 4-10 and SWAN 2 Concentrator Label, Configuration
Track-ID on page 4-10).
WAN 00014
Cause. The specified modifier-name did not include a required modifier-value.
Effect. The command has no effect.
Recovery. Examine the command syntax in Section 6, SCF Commands. Supply the
value for the modifier-name, and retry the command.
WAN 00015
Cause. The specified modifier-name is either not defined properly inside the
associated PROFILE or is not included.
Effect. The command has no effect.
Recovery. Look up the modifier definition in the appropriate data communications
subsystem manual. Redefine the modifier specification accordingly, and retry the
command.
WAN 00016
Cause. The specified attribute is not valid for the specified object.
Effect. The command has no effect.
Recovery. Examine the command syntax in Section 6, SCF Commands. Remove the
invalid attribute, and retry the command.
00014 Value should be supplied for modifier
modifier-keyword.
00015 Definition of modifier modifier-name is invalid
inside profile.
00016 Attribute attribute-name is not allowed for
object-type object-name.