WAN Subsystem Configuration and Management Manual

SCF Messages
WAN Subsystem Configuration and Management Manual—522463-011
A-7
Effect. The command has no effect.
Recovery. Change the object name or delete the object from the subsystem that owns
it, and retry the command. You can determine the owner by using the TACL PPD
command. For example, if the object name you specified was $Z06P:
5> ppd $Z06P
Name Primary Backup Ancestor
$Z06P 0,313 $ZZSTO
The command response shows that the Storage subsystem ($ZZSTO) owns the
process.
WAN 00021
Cause. Before any device or process is added, the name is reserved using the
Config_Process_Name_Reserve_ procedure. The procedure has returned an error.
Effect. The command has no effect.
Recovery. This could be a serious problem. Contact your service provider.
WAN 00022
Cause. Your configuration is not correct. When adding an ADAPTER object, the
specified attribute was not located in the indicated subvolume. If you don't know where
the file is, use the TACL FILEINFO command to locate the file. For example, to find the
SNMPCODE, C7849P00, issue this command:
6> FILEINFO *.*.C7849P00
$DATA6.T7849F40
Code EOF Last Modification Owner RWEP PExt SExt
C7849P00 510 49152 3-Jan-96 8:52:58 165,222 "NUNU" 8 16
The command response shows you where the file is. Copy the file to the specified
subvolume.
The SNMPCODE attribute is made optional for both the SWAN and SWAN 2
concentrators because the SNMP module is linked with the SWAN NonStop Kernel
(G06.07 and later RVUs) and does not need to be downloaded.
Effect. The command has no effect.
Recovery. Copy the file to the specified subvolume, and retry the command.
00021 Error error-number occurred while reserving the name.
(Config_Process_Name_Reserve_)
00022 attribute-name should be in the subvolume
$SYSTEM.subvolume