WAN Subsystem Configuration and Management Manual

SCF Messages
WAN Subsystem Configuration and Management Manual—522463-011
A-10
WAN 00030
Cause. A mismatch was found in the filecode of the file in the command. Valid
filecodes for adding or altering a device, process, task, or profile are as follows:
Effect. The command has no effect.
Recovery. Verify that the filecode matches the allowable filecodes, then retry the
command.
WAN 00031
Cause. The file specified is not a disk file type.
Effect. The command has no effect.
Recovery. Retry the command supplying a file of disk file type.
WAN 00032
Cause. Only a $NCP device can be of type 62.
Effect. The command has no effect.
Recovery. Check the type and name of the device before adding or altering again.
Only a $NCP device can be configured as type 62.
WAN 00033
Cause. Only Conmgr process can be of type 50.
Effect. The command has no effect.
00030 FILE: file name file code is invalid. Valid file codes
are:file-code(s)
Object-Type Valid Filecodes
DEVICE 100 & 700
PROCESS 100
PROFILE 832
TASK 510
00031 The FILE, file name is not a disk file
00032 Cannot add or alter a device of type 62 other than $NCP
00033 Cannot add a process of type 50 with a non-numeric name