WAN Subsystem Configuration and Management Manual

SCF Messages
WAN Subsystem Configuration and Management Manual—522463-011
A-15
WAN 00049
Cause. The WANMgr process is unable to launch a process on a remote machine.
Effect. The configuration of a concentrator, device, process, profile, and task failed.
Recovery. Use IOPOBJECT, PROGRAM, SNMPCODE, and ESSENTIALCODE
available in the current node.
WAN 00500
Cause. The specified attribute has been included more than once in the command.
Effect. The command has no effect.
Recovery. Delete the duplicate attribute, and retry the command.
WAN 00501
Cause. This is an internal error that occurred while parsing an SCF command.
Effect. The command has no effect.
Recovery. This could be a serious problem. Contact your service provider.
WAN 00502
Cause. More than one object name was specified in the command.
Effect. The command has no effect.
Recovery. Examine the command syntax in Section 6, SCF Commands. Correct the
command syntax to make sure the command only has one object-name, and retry
the command.
WAN 00503
Cause. The specified attribute is required but is missing from the command syntax.
Effect. The command has no effect.
00049 The IOPOBJECT, PROGRAM, SNMPCODE, and ESSENTIALCODE
cannot be on a remote node.
00500 Duplicate attribute: attribute-name.
00501 Internal error: Case value out of range
00502 Multiple object names are not supported
00503 A required attribute is missing: attribute-name.