WAN Subsystem Configuration and Management Manual

Sample Router Configuration
WAN Subsystem Configuration and Management Manual—522463-011
B-2
Configuration Steps
Example B-1. Sample Router Configuration
! Partial Cisco Router Config which highlights only the changes required.
! Assumptions:
! NSK1 network is 192.168.10.0
! NSK2 network is 192.168.11.0
! SWAN1 network is 192.168.12.0
! SWAN2 network is 192.168.13.0
! Enable ip forwarding of all bootpc and bootps packets
ip forward protocol udp bootpc
ip forward protocol udp bootps
!
! Config of NSK1 interface
int ethernet 0
ip address 192.168.10.1 255.255.255.0
ip directed-broadcast
ip helper-address 192.168.12.255
!
! Config of NSK2 interface
int ethernet 1
ip address 192.168.11.1 255.255.255.0
ip directed-broadcast
ip helper-address 192.168.13.255
!
! Config of SWAN1 iinterface
int ethernet 2
ip address 192.168.12.1 255.255.255.0
ip directed-broadcast
ip helper-address 192.168.10.255
!
! Config of SWAN2 interface
int ethernet 2
ip address 192.168.12.1 255.255.255.0
ip directed-broadcast
ip helper-address 192.168.10.255