WAN Subsystem Configuration and Management Manual

WAN Subsystem Configuration and Management Manual—522463-011
1-1
1 Configuration Quick Start
This section describes your initial WAN subsystem configuration and how to verify that
all required WAN subsystem processes and objects are configured and started.
Initial WAN Subsystem Configuration
•
Configuration File Contents
•
HP Manufacturing Naming Conventions (G06.26 and Earlier RVUs) on page 1-3
•
HP Manufacturing Naming Conventions (G06.27 and Later RVUs and H06.03 and
Later RVUs) on page 1-7
•
Determining the Initial Configuration of a SWAN Concentrator on page 1-9
For more information about the WAN subsystem, see Section 2, Overview of the WAN
Subsystem
Configuration File Contents
The following configuration files which are located in the $SYSTEM.ZSYSCONF
subvolume were used to create your initial system configuration:
•
SCF0000
•
STARTCOM
•
STARTSCF
Note. Throughout this manual when a distinction between a SWAN concentrator (T3880) and
a SWAN 2 concentrator (T3881) is not required, SWAN concentrator is used as a collective
term.
Topic Page
Initial WAN Subsystem Configuration
1-1
Verifying the Initial WAN Subsystem Configuration 1-18
Troubleshooting Tips 1-20
Installing the SWAN Concentrator 1-25
Changing the Initial WAN Subsystem Configuration 1-27
Note. All SWAN concentrators ordered with an Integrity NonStop NS-series or
NonStop S-series server are configured for you by HP manufacturing. If you ordered a
SWAN 2 concentrator without a server, you must configure the SWAN 2 concentrator yourself.
Do not use this section to configure your concentrator; instead, use Section 4, Adding a SWAN
Concentrator.